banner



How To Change Battery In Alienware 17 R3 Laptop

Introduction

This guide will show y'all how to supervene upon the bombardment for your Alienware 17 R3. Be sure yous have all the required tools before you begin.

For your safety, discharge your battery below 25% earlier disassembling your device. This reduces the chance of a unsafe thermal effect if the bombardment is accidentally damaged during the repair. If your battery is swollen, take advisable precautions.

  • Phillips #1 Screwdriver
  • iFixit Opening Tool
  • Anti-Static Wrist Strap
  1. Turn the computer off.

    • Plow the computer off.

    • Disconnect the charging cable from the figurer.

    • Failure to unplug the charging cable could result in dissentious the calculator or seriously injuring yourself.

    • Wear the anti-static wrist strap to forbid any electrical shock to the components. Shocks may harm the components.

  2. Unscrew and remove the two 4mm Phillips #1 screws from the cover.

    • Unscrew and remove the ii 4mm Phillips #1 screws from the encompass.

    • Think to put the screws in a safe place and then you tin find them all during re-associates.

  3. Pull up and slide the cover off.

    • Pull upwards and slide the cover off.

  4. Unplug the black wire with the yellow tag to disconnect the battery. Unplug the black wire with the yellow tag to disconnect the battery.

    • Unplug the black wire with the yellow tag to disconnect the battery.

  5. Unscrew and remove the four 3mm Phillips #1 screws holding the hard drive in place. Unscrew and remove the four 3mm Phillips #1 screws holding the hard drive in place.

    • Unscrew and remove the four 3mm Phillips #1 screws holding the hard bulldoze in place.

  6. Unscrew and remove the four 2mm Phillips #1 screws holding the casing together. Unscrew and remove the four 2mm Phillips #1 screws holding the casing together.

    • Unscrew and remove the four 2mm Phillips #1 screws property the casing together.

  7. Remove the plug from the hard drive. Lift the hard drive out and set aside.

    • Remove the plug from the difficult drive.

    • Lift the hard drive out and gear up aside.

  8. Unscrew the one Phillips #1 screw holding down the bottom of the M.2 chip.

    • Unscrew the ane Phillips #1 spiral holding down the bottom of the M.2 chip.

    • Pull the K.ii chip straight out of its socket.

  9. Unscrew and remove the eight 3mm Phillips #1 screws (located in areas labeled "P").

    • Unscrew and remove the eight 3mm Phillips #1 screws (located in areas labeled "P").

  10. Carefully disconnect the four flex cables.

    • Carefully disconnect the four flex cables.

    • To unlock a ZIF connector, use the tip of a spudger or your fingernail to flip up the pocket-sized, hinged locking flap. Carefully slide the unlocked cable out of the socket.

  11. Remove the six 4mm Phillips #1 screws on the side and the two 10mm Phillips #1 screws on the top.

    • Remove the 6 4mm Phillips #1 screws on the side and the two 10mm Phillips #1 screws on the top.

  12. Flip over the laptop and open it.

    • Flip over the laptop and open up it.

    • Insert the spudger along the edges of the laptop and gently pry upward to lift the keyboard console.

  13. Remove the six 4mm Phillips #1 screws holding the battery in place.

    • Remove the six 4mm Phillips #one screws property the battery in place.

  14. Unplug the two sets of wires from the motherboard. Unplug the two sets of wires from the motherboard. Unplug the two sets of wires from the motherboard.

    • Unplug the two sets of wires from the motherboard.

  15. Lift out the battery pack.

    • Lift out the bombardment pack.

Team

4 Comments

Source: https://www.ifixit.com/Guide/Alienware+17+R3+Battery+Replacement/77371

Posted by: andersonlifee1972.blogspot.com

0 Response to "How To Change Battery In Alienware 17 R3 Laptop"

Post a Comment

Iklan Atas Artikel

Iklan Tengah Artikel 1

Iklan Tengah Artikel 2

Iklan Bawah Artikel